Return to flip book view
(800) 245-6860primeline.netprimeline.netPrivacy coverThe Privacy Cover maximizes privacy by covering common see-thru gaps in restroom stalls. Clear rigid vinyl attaches to stall with 3M adhesive tape. Black colored exible ap obscures gap view.U.S. PATENT NO. 8,627,610ASSURES PERSONAL PRIVACY:Eliminates most door and panel gaps.Flexible vinyl ap adapts to multiple applications. The black color obscures vision.QUICK AND EASY TO INSTALL:Self-adhesive for fastener free installation.Cut to t for various partition door installations.WORKS ON ALL PARTITION STALLS:Clear rigid vinyl blends to all partition colors and materials.BRO-7-2 010Adhesive stripClear rigid vinylBlack exible vinylLocator tabHinged SideLatched SideRigidFlexibleRigidFlexible650-1010 (2) 58 in. pieces per set(poly bagged) / 5 sets per carton
primeline.netprimeline.netA) Latch Side:Measure from top of door to top of strike / keeper, then measure from bottom of strike / keeper to bottom of door.Pre-Cut the “Privacy Cover” with either (Multi-Purpose Snips, Diagonal Pliers or other safe cutting device) to the above measurements and align the cover to the post. Clean up the rough edges with a utility knife or ne grade sandpaper if necessary.Always place the cover on the side opposite to the direction of the door opening.Clean surface of post, where the “Privacy Cover” is to be mounted, with (isopropyl) rubbing alcohol. Do Not Use Household Cleaners.Remove adhesive backing from at surface of the cover. Use Locator Tab to assist in placement. Press rmly to the post and apply pressure, using an up and down motion to set the adhesive.B) Hinge Side:Toilet partition doors may be hinged with dierent style hinges, installation will vary slightly, but cover will always be placed on the post side opposite to the direction of door opening. To install the privacy cover, use the same cutting, prepping and application directions listed in the “Latch Side” instructions above, in addition to the appropriate hinge type instructions below.Pivot Hinge:Measure from top of door to top of top hinge, and then measure from bottom of the top hinge to top of bottom hinge. Usually it will not be necessary to place “Privacy Cover” below the bottom hinge.Surface Hinge:Measure door from top to the bottom. Hold “Privacy Cover” to post and determine if adhesive surface will make contact with the hinge fastener heads. If this condition exists, merely cut out a wedge of material at the point of contact with the fastener heads to allow the cover to make an unhindered at contact to the post.Installation InstructionsFor Door Gap Applications (Apply to Post only.)Cutting Tool OptionsTools Required:Rubbing AlcoholMeasuring TapePencilMulti-Purpose Snips Diagonal PliersRestroom doorPartition postClear rigid baseLocator tab3M TapeFlexible black privacy stripSquare edged doors & postsRestroom doorPartition postClear rigid baseLocator tab3M TapeFlexible black privacy stripRound edged doors & posts