Return to flip book view
We found locations to insert the Control Panel and Digital Readout with NO DRILLING and still hide wires inserted into panels without seeing. Note: Escort Readout may stay on 3 to 4 Minutes, after vehicle shut down.
IGNITION POWER SOURCE Right rear of truck has an accessory Port. !Will shut down when vehicle shuts down. Removing Panel Exposes Accessory access as well as a battery terminal with fuses.
FRONT RADAR SHIFTER SHIFTER Remove total trunk liner, then remove lower plate to find a cavity with a large multi - wire plug. Unclip plug allowing further space to locate FRONT RADAR SENSOR. Reposition plug under Radar Sensor . Secure mounting with Brackets onto plastic ledge . !Note wires from Front Shifters FRONT RADAR SENSORFRONT SHIFTER WIRES
LOWER !PANNEL !REINSTALLED Open Space - Driver's Side !for Shifter Module!Perfect Resting!Place for Shiter !Module - Driver’s Side !Front Radar and Shifter Wiring
Factory Gromit to run wires into !vehicle cabin. All Wires Front & Back Are Run Up On Drivers Side To Meet Up With MAX Ci Interface. Ground Also Found at This Location . Ignition Found at Right Rear Power Port USB Port for Update can be Tucked Behind Kick Panel for Future Updates Run Test Before Organizing Wires and And Mounting Interface
REAR RADARSHIFTER SHIFTER NOTE: Would have had BOTH Shifters with “Bumps” facing IN or OUTABOVE - When routing wires from shifters, a hole will be needed to route wires along factory trunk hinge, follow factory cables. RIGHT - Driver’s side trunk trim panel will be needed to access routing of Shifter wires as well as installing GPS Ant. !When removing panel, held with double face tape, there will be an open area to install GPS ant to get reception thru the back deck and rear windshield. !Note: Do not install GPS ant. Under Front Windshield. Glass coating will effect reception. Behind panel, !two factory openings !enable installation! of GPS Ant.Route Shifter Cables within !Trunk Hinge Cover Rear Radar Install - For secure and level positioning the rear bumper was removed and unit placed between left rear sensor and White Back Up LED’s in Center of Bumper.